Frequently asked questions
Fit, installation, cleaning and care.
Standard 4" dryer ducts measuring 3.95" to 4.15" across. Measure your dryer outlet and wall vent before you buy.
About 4½ inches. The 90° elbow lets the dryer sit much closer to the wall than a looped hose.
For the most secure hold, yes: push the dryer back so the 90° elbow sits flush against the wall. If it cannot sit against a wall, wrap the connection with the included HVAC sealing tape.
Yes. It can point any direction you need; it does not have to sit straight up.
Yes. Put the seal ring on the wall duct and press the assembly onto it.
It depends on the kit. The Elbow Kit with Hose and the Straight Kit with Hose include a flexible dryer hose that can be trimmed shorter. The 90° Elbow, Double Elbow and Elbow + Straight kits do not include a hose.
Yes, you can disconnect the ends whenever you clean the vent. The seal rings are reusable; just clean them thoroughly.
Yes. Unsnap the fingers from the hose, replace the hose, and snap the fingers back on.
Yes. Most dryers run their exhaust at 100°F to 160°F. Snap to Vent is made from heat-resistant plastic rated well above dryer temperatures.
Snap to Vent connects to the standard 4" exhaust duct used by most residential gas and electric dryers.
Still have a question? Contact us and we will help you pick the right kit.
Found your answer?
Pick the kit that fits your laundry room.